Hello
A colleague encounters a problem when opening an assembly,
Some files are read-only and do not load.
We have tested on other stations without being able to reproduce the problem.
These files are outside PDM.
Do you have any leads?
Have a nice day
Hello
What version of SW are you working on?
If you open the room directly, what happens?
Apparently, there must be a discrepancy in the SW version between the part (old, or even very old) and the version used to open the assembly.
We are under SW2021
The part is read-only and can be "reactivated" again in the assembly
Ok, it's a possibility that the parts are old, but I open them on my computer (where I'm not read-only) and save them, this should solve the problem?
If so, I did it and no improvement on my colleague's position.