Threading - Material removal with sweeping

Out of category
1

Hello

 

I'm desperately looking to create a (physical) thread with material removal output on a 3D printer. It's a project started on SW2012, resumed under SW2017.

My problem, SW refuses to do the kidnapping for me. I did a test on a simple piece > Its working, the tutorials on youtube > OK.

I'm starting to think that "babywearing" is a problem, or... I don't really know...

If a good soul goes through this... I'm a taker.

Attached is my piece

 


haut_forum.sldprt
2

See attachment

attached file SW 2017

I fired your repetitions because there was a problem

and you have to create a meeting point between your spiral and the swept matter removal triangle

and make sure that the base of your triangle is not greater than the pitch of the propeller

which moreover is to make sure to start your propeller outside your room

The step is  not good for you to see and make the modifications

otherwise it doesn't work

@+ ;-)


haut_forum_jojo.sldprt
2 Likes