Good evening.
When I do a slide function in one of my assemblies, I only have the choice to center it...
Why don't I have the ability to drag from one point to another?
Thank you
Good evening.
When I do a slide function in one of my assemblies, I only have the choice to center it...
Why don't I have the ability to drag from one point to another?
Thank you
Hello
we need an example perhaps.
Pay attention to the direction of your selection, slider/slide
Did you have solidworks 2015? Because the fact that it can be slid is a new feature for 2015...
Check your slide and advanced constraints
http://help.solidworks.com/2012/French/SolidWorks/sldworks/Width_Mates.htm
@+
If you take a rectangle for example and you do a slide function with your large faces. You can then "slide" along these faces (i.e. set the small faces in motion).
Now, if you put a positioning constraint on these small faces... Your room is centered by its large faces and can no longer move
Hello
Be careful, you have to select 4 sides, as in the following video:
https://youtu.be/6ffoTK8EouU?t=24