Numbered cone graduation

3D Design Volume Model
1

Hi everyone, 

I need to engrave the next cone and display the corresponding number every 10° (10-20-30....350).

Do you have a quick fix? I tried a winding but I must be doing it wrong, it doesn't work...

Ideally, you need a removal of material so that it can appear during 3D exchanges and on DXF files.

 

Thank you in advance,


graduation_cone.png
2

Hello

I think that with a removal of material followed by a circular repetition you should get there. We have to do a removal for the primary graduation in degrees and then another for the secondary graduation, let's take every 10 degrees. In my example I made a circular engraving but of course any type of profile is suitable as long as there is no overlap. I did the 0 marking first because the winding function is much faster than if it is done after the graduations.

Have a nice day


cone_gradue.sldprt
4 Likes
3

You have to use the "Winding" function

4

Here is a tutorial


creer_un_texte_sur_une_surface_non_plane_0.doc