Hello
I have installed Solidworks 2018 sp3 and myCADtools 2018 however I am unable to activate the add-in because it does not point to the right path as you can see in the attached photo. I started the installation again but still the same problem. I have done some research but I have not found any solutions, which is why I am turning to you to solve this problem.
Hello
This problem can occur under certain circumstances when user rights are not sufficient on the session that is running SOLIDWORKS.
Changes have been made to the myCADtools 2018 SP0.2 Setup for this kind of issue. This new setup is available since 11:00 this morning.
Could you try to uninstall myCADtools and then install myCADtools 2018 SP0.2 (available for download in the myCADtools section or directly here)
Thank you for keeping me informed.
Sincerely,
Mickael CORDERO