Unable to set up an equation with SLD 2015 on a 2012 version part

3D Design Volume Model
1

Hello

We have just updated solidworks 2012->2015. We have parts, version 2012, with equations whose value and deletion state change according to the configuration. In 2015 this poses problems (impossible to have equations with the same name), according to the help it is possible to configure the value of the equations

Conditions limiting the use of configurable equations

For files created with SOLIDWORKS 2013 or earlier, you can use configurable equations unless :

  • The model includes parts families.
  • At least one equation has been deleted in one of the configurations.
  • The model has at least two equations with the same name, for example, D2@Esquisse1.

To use configurable equations with one of these existing files:

  1. Remove conflicts by doing the following :
    • Remove part families.
    • Delete the deleted equations.
    • Make sure that each equation has a unique name.
  2. Save the file with SOLIDWORKS 2014 or later, and reopen the file.

Related concepts

Families of parts and equations

 

When I do this I can't configure the values, even if I delete all the equations and recreate them. Starting from a new room it works.

Has anyone ever had this problem?


equation3.jpg
2

Hello, I think you're going to have to redo your equations, that's 4 versiion difference too many differences I think.

Kind regards

3

Apparently it's a corrupted file problem...