Hello
How to insert 2 BOMs with different columns in a drawing but that the 2nd one takes into account the item numbering of the 1st,
because when I do it, the article numbers are not the same between the 2 nomenclatures.
Thank you.
Hello
I think it's not possible because the article numbers (the first column) correspond to the bubble (automatic or not).
The only possibility would be to save the BOM in an Excel table, then reinsert this table, but in this case, you have to do this again each time the assembly is modified, because the BOM is no longer directly linked.
2 Likes
As @Lucas says
The bubble numbering corresponds to the articles of your drawing
on the other hand
you can increase fields
(the columns, the rows) of your nomenclature
@+ ;-))
On the other hand, at home I have always had a bug.
I must not change the scale of the view that I use for the bubbles otherwise the bubbles will not follow.
I need to do the bubbling first and then the scaling.
2 Likes
@Bart: open a new question! ;-)
1 Like
@gt22,
I need 2 BOMs because there is one on which I make fields appear that is only used for injection into our ERP, this BOM is placed next to the plan and another with fewer fields which is above the cartridge.