Hello
We're going to have to make some crates on Catia and for that, I wanted to know how to integrate parameters that I managed to create (length, width and thickness) into a property of a BOM.
Looking forward to your response.
Kind regards.
Hello and welcome;
I don't have Catia but you will probably find clues here:
Kind regards.
1 Like
Hello
At the CATPart level:
Create the property under each component (it's best to create them in a starting template before starting your design)
For the practical aspct create a user parameter that will drive the
Then
The bill of materials is prepared at the product level:
Definition of formats
And add the desired properties
Generate the nomeclaure in the drawing by selecting the Product
There you go 
Kind regards
Hello
Thank you for your answer.
I follow your tutorial which works. However, can we put several parameters in a property of the share (e.g.: Product description = value of length x value of width x value of thickness).
Looking forward to your response.
THANK YOU IN ADVANCE.
Kind regards.
Hello
Thank you for the speed, I'll try right away.
Have a nice weekend.
Hello
I'm coming back to you because I have a problem during the validation of the formula.
What does it correspond to.
Kind regards.
Hello
I have just found my mistake, the gentleman can no longer read.
Kind regards.
Have a good weekend
If the topic is well resolved, please close the topic by selecting the best answer.
2 Likes