Interrupted view interval

2D plans Layout
1

Hello Community,

I would like to improve my ordinary by changing the default interval when you perform an interrupted view.

By default, SolidWorks sets it to 10mm. I wish it was 3. (see attached image)

Do you know how much you can adjust this parameter?

 

Thanks in advance 

Fred.


sans_titre.png
2

Hello

If you go to the document properties, you can set this value. If the modeling does not work when you open another drawing, then you should save it directly to the drawing model.

 

Gauthik


valvueinterrompue.png
2 Likes
3

Hello

you have to go to tool==>option==>properties of the document==> wrap==> display of the break lines and where there is 10mm you have to put 3mm


intervalle_vue_interrompue.jpg
2 Likes
4

At the same time  ^_^

1 Like
5

Hello Gauthic67 :-)

Even if it works and you still want to have 3 instead of 10 you have to do as you say

""" you have to save it directly in the drawing template """ Otherwise with each new document you have to go and change the value which is a bit of a pain in the ass.

Kind regards

1 Like
6

after modifying it as described it's saving in the settings of Solidworks... I tested by restarting Solidworks and then my PC and in both cases it stayed...

1 Like
7

Thank you AC cobra

It remains if it is the same saved coin. But if it's a new part, it takes up the variables of the model, i.e. 10mm in Frédéric's case

1 Like
8

Hi everyone

 

Thank you for your help.

On the other hand, I had to re-register my background plan templates.

3 Likes