ISO 8015 - diameter greater than 600

jean-michelhuet · August 28, 2013, 4:02pm

Hello

I would like to know the ITs according to the ISO 8015 standard for diameters of 625 and 1040.

Does this standard still apply?

Thank you in advance.

gerald · August 28, 2013, 6:23pm

Good evening

It was revised in 2011 and there is only Wikipedia information accessible for free

http://fr.wikipedia.org/wiki/Tolérance_géométrique

tomalam · August 29, 2013, 7:38am

Hello

I found an adjustment table that goes in large diameters, but I don't know if it's ISO8015

Thomas

bastienvogel · August 30, 2013, 4:19pm

Comparing the links of @tomalam (http://http://www.skf.com/pages/jsp/catalogue-table.jsp?id=tcm:81-6515) and the latter (http://barreau.matthieu.free.fr/cours/ajustements/ ) we would say that we are back on our feet so I think we can rely on the table find by @tomalam.

Sincerely, Bastien