I need advice for a good simulation of this part

Out of category
1

A part of a table in question supports weights of about 1000 kg, subjected to bending stress. Thank you in advance for your help.

Material: Steel 


notre_modification.rar
2

Hello

If you want help, you have to attach the parts of the assembly.

To do this, you have to do according to the SW version you have.

File ==> Composition to take away
or

File ==> pack and go

If you have already tried to make a simulation you must attach the results in the files

Kind regards

PS: Are you a student???

2 Likes
3

yes I'm still a student, thank you for the advice 

4

Hello 

If you want to share a .sldasm file you need the .slpdrt files that are in the assembly otherwise it doesn't work. 

A board rather exports .step, it works better.

Kind regards.

2 Likes
5

Hello

   A screenshot can also be used so that we can advise you.

  Then, the scenario(s) considered, the possible scenarios and the validation criteria can be critical for the results of a simulation.

  Are you working on resistance? to deformation? to something else?? . Have you planned a safety factor?

 

  N.B.: depending on the type of product you design/validate, there may be standards, for example we will not use the same coefficients to calculate the behavior of a crane (see FEM handling manuals) or a bridge (see Eurocodes) and it also depends on the country.....

1 Like