I'm not able to draw the drawing in photos, I'm a CEGEP student. I need drawing and help please

Out of category
1

I have a project in CEGEP and the teacher is not able to help me make this drawing, if someone here is able to do it or help me I would be super relieved.

 

Thank you.!


img_20191018_150022.jpg
2

Hello

Not very complicated; just draw the Z-shaped part with the sheet metal function, then then all you have to do is use the folded sheet metal function for the two wings and then add the holes.

6 Likes
3

Hello Mario

regrazde here

https://www.youtube.com/watch?v=3HX37Mhv2Cc

And here too it is the basis https://www.youtube.com/watch?v=tHIozXRMfJ4

Kind regards

PS: between us when you say (the teacher is not able to help me) it would surprise me a lot because even here we won't do the work for you even if we are ready to help you ;-)

Patience you will succeed

5 Likes
4

Hello, I agree with the previous message, the Sheet Metal function is the most efficient! You can use the thin extrusion function too but you won't have the same rendering. You can use the unfolded function for your drawings.

 

5

I don't have a hard time drawing with sheet metal, except that I don't get what I want to do. I want to make a smooth transition between the radius and the cylinder on both sides.

Thank you for your help!


test2.jpg
6

You cut the last fold 

and you create a smoothing instead

@+

 

1 Like
7

I have never used the smoothing options with surfaces, I put the solidworks file and if someone can modify it and send it back to me once corrected I will see the changes made and I will understand because I am very visual. The solidworks is 2019 at my place to do the tests and understand. Thank you very much. The explanations so far are too broad for my skills. 

 


test.sldprt