My license no longer works after a reinstall

Out of category
1

Hello

I reinstalled my PC and I can no longer install solidworks, what should I do?

Thank you

2

Hello

What is the message?

If it is the license, you can see them in the "My Contracts" section of the "Support" tab.

If this is a problem, I invite you to create a "Create a new ticket" in the "Support" tab.

Have a nice day.

3

Thank you for your answer

but I can't find the My contracts section

4

Did you transfer your license before reinstalling your PC?
-if so, check with support, it sometimes sucks (especially on old licenses);
- if not, see also with the support that will release the license so that you can get it back.

It may seem mocking or humorous but normally, a reinstallation goes without any problem.

I believe that even if you no longer have a maintenance contract, you can get this service from SW since the license is not limited in time.

The support tab only appears if you are a Visiativ/Axemble customer.

5

Hello

Have you reinstalled it after spitting?? If so, you may still have a Solidworks open. Check in the task manager if there is a Solidworks open.

6

Hello

At what point exactly does it stop?