Macro to set the deletion state & config of a part in an assembly

Out of category
1

Hello

I have a new problem, I have an "Assembly A" with four configs (A1, A2, A3, A4), in this assembly I have three parts "P1, P2, P3" each part has two configs "P1a, P1b, P2a, P2b, P3a, P3b" all the parts are in a deletion state. 

I would like, if possible, to have a macro that can "cancel the deletion state" of the part "P2" in the configs (A1, A2, A3, A4) of "Assembly A".

Then have a macro that selects the "P1a" config of the "P1" part in all the configs (A1, A2, A3, A4) of "Assembly A".

When I record a macro it only works on the A1 config, can you help me?

 

2

Hello

See if the utility HERE meets your needs.

Kind regards

3

Your solution seems to match my problems but unfortunately I can't install it (protection). 

4

Yes, it's an executable file so either trust and exclude from the antivirus scan or no trust and too bad!!

Kind regards