Hello
I already asked the question yesterday but I still can't get the flat and my client is getting impatient.
Thank you to the one who will be able to achieve this miracle:)
Kind regards
limon.stepcapt_vue_3d.pngcapt_vue_du_dessus.pnglimon222.sldprt
Hello @jeremy.debomy
You should specify what you want to put on the table.
I note that an answer has been given to you here https://www.lynkoa.com/forum/conception-3d/mise-plat-dun-limon-d%C3%A9billard%C3%A9?page=0#answer-4049506
For your new request - are these the tubes made of surface and which have a very curious connection and an unusual shape
or is it the sheet metal steps that receive the wooden boards.
Kind regards
PS: I note that you use a student version when you say "my client..... )
2 Likes
bjr
Attached is a SW2020 file with the flattening of the 1/4 turn -4 sides-, also tangency problem!! connection between the right part of the bottom and top tube with the rotating part!!
Kind regards
limon_deplies.sldprt