Bubble drawing and assembly

3D Design
1

Hello

In an assembly containing other assemblaged and pièced I want to use a balloon to retrieve the "configuration properties" of one of the assemblies.

I only have access to the propropriations of the assembly, the drawing, or the parts it contains, but not the assemblies containing some of those parts.

I tried the method here without success.

https://www.lynkoa.com/forum/mise-en-plan/propri%C3%A9t%C3%A9s-dun-sous-assemblage-dans-mise-en-plan

I don't have access to the assembly tree

Thank you

 

 


capture_decran_2021-12-02_151345.png
2

Hello, see this, personally I prefer to go through a first level nomenclature;) so that the balloon follows the subset to which it is attached, 


doc1.pdf
2 Likes
3

I proceed in the same way. Table of nomenclature 1st level. The bubble attaches to the 1st level subassembly. Without a BOM table, the bubbles attach to the part (top level)