mooky
1
Hello
I work in the safes and I have to make plans of the safes with the door closed and with the door open to indicate the size.
I would like to know if it is possible in the same drawing to have a view of my assembly with the door closed and a view with the door open
thank you in advance ;-)
bart
2
Hello
Yes, just create configurations (one open and one closed)
Then, when the configs are created, you have to configure a constraint so that it is activated only at a particular config.
Example: closed config > the door is constrained in coincidence with the frame
config open > the door is constrained with an opening angle.
If it's in a simple part and not an assembly, you have to configure the "copy/move" function
config.png
6 Likes
mooky
4
ah thank you its going to help me a lot ^^ on the other hand how do you create a configuration?
ah I hadn't seen the 2nd post sorry =)
1 Like
remrem
5
Once your configs are created. In your drawing you should use "View from another position:
http://help.solidworks.com/2015/french/solidworks/sldworks/t_insert_alternate_position_view.htm
5 Likes
mooky
6
thank you both its removes a big thorn in my foot =)
1 Like