Editing Tangent Edges in Drawing Display

Out of category
1

Hi all

I want to display the tangent edges of a bend that follows the standard, i.e. that the end of the stroke does not touch the contour of the part

I know how to change the visibility and font of the stroke and also how to make the ends of tangent edges appear or hide.

On the other hand, I can't change the distance between the end of the line and the outline of my part.

Does anyone know where the setting to change is?

 

Thank you in advance

 

2

Right-click on the view, stop tangent and hide the ends on SW 2018 version (see gif attached)

https://i.imgur.com/xpNKvV0.gifv

 

1 Like
3

Or in the general options:

1 Like
4

Thank you, I know this step but on the other hand the distance between the end and the contour of the part is too great.

So I'd like to be able to change the interval between the end of the tangent edge and the edge of the part. Do you know how to do it?

5

I don't think we can change this length ourselves. And if it were feasible, it would be offered in the same place in the options.

1 Like