Hello
I downloaded a library with multiple profiles.
I want to change the thickness of the tube 2 to 3,
I have a message which is as follows:
Changing this value will result in invalid geometry. The previous state of the sketch will be restored.
Do you have an idea or I could find the dimensions of the different radii of the profiles etc.
030 x 30 x 2.SLDLFP (168 KB)
In stainless steel I was told inner radius = tube thickness and it's rather true (but not always with some manufacturers even if not very far)
If not, ask your tube supplier if you have one.
2 Likes
As said by @sbadenis, check your rays so you don't make a suck with the change in thickness
Now, in your specific case, I think that the inner radius of your R2.5 will go from R0.5 to R-0.5.
So, if you modify your R2.5 to R3.5 beforehand, it should pass 
5 Likes
Thank you I hadn't paid attention ^^'
1 Like