Changing Solidworks ePDM Custom Property

Hello

I want to modify a custom property in Solidworks by concatenating it with 2 digits, but subject to the length of my property. This is normally possible with the MyCAD Integration utility and it works but only on the file and not on the configurations despite the option used in Integration. Note that these plans are, moreover, managed in ePDM. I think I need a macro that takes up what Integration does Would anyone have a solution to get out of this impasse?

Small screenshots would help to understand the problem (and therefore to solve it)

;-)

I have the impression that this person was not so much in a dead end ^ - ^ 

Hello 

Yes it is possible under integration.

In the options, we read the variables, of the active config, named config .... and we can put all the config back in config active...... as needed. 

Or image could help people better understand your problem. 

 

 

Cdlt