Routing module for pvc piping

Hello;


I've been discovering the routing module for a few days.
I use it for PVC glued pipes.
I've already set up a few components for my library.

 


I'm having a problem with discounts that is blocking me in my routing.
  In PVC pipes, the reductions are made by entrenchment in the bends, very etc. Unlike welded piping where the reductions are put in the continuity of the piping.


So I only have one connection and routing point on this type of PVC parts (where for stainless steel reduction so welded there are two connection points and one routing point). This is annoying to restart the routing on the other side (after the reduction).
I tried by putting a constraint between the tee and the reduction but it blocks me from continuing the routing correctly and keeping the routing flexibility.


If people who know about this module could tell me how to do it, it would help me greatly.

 


Kind regards


Florian

And if you cheat and put 2 connection points spaced 0.1mm apart for example.

1 Like

If I do that, the tube won't start from the right place and it will always block me if I want to put the reduction in a tee. Because the tube must arrive in the reduction (which is nested in the tee) and then the tube must come out at the other end of the tee.