Hello again,
Out of curiosity, I just redid the Solidworks Drawing Views module.
The error is on part 6 and 7, the representation is the same for part 3.
That is to say it is the representation of bet 3 that is repeated on parts 6 and 7.
Too bad for me, it's precisely this one that interests me.
Kind regards.
Alain RANCHON
Hello
I am looking into this and will keep you informed as soon as possible.
Thank you
Kind regards
@A.A. The problem is solved. Can you try it again?
Thank you
Kind regards
Hello
Thank you it works ...@+.
AR.
Cool! Thank you for your feedback.
Kind regards
Hello again,
I can't finish the 2018 new training, here is the attached message.
I validated all the steps, but not the final validation.
Kind regards.
Alain RANCHON
It's okay just one step that is displayed now, to continue ...@+.
Good evening
Could you clear your browser's cache? You should have an 8th "8_Treehouse" section before the certification MCQ on the new SW2018 products.
Thank you
Kind regards
Good evening
Indeed there was this "treecover" chapter that did not appear, I was able to finish the new 2018 training.
Thank you @+
Alain RANCHON
Well done!
Hello
Just a question that comes to mind, is it possible to use a visualization cube on an assembly to allow me to determine a volume to make a package?
Thank you for your answer, all of you.
Kind regards.
AR
Hello
It would be better to ask this question by creating a new discussion topic so that the whole community can answer you (Copy/Paste in the forum).
Kind regards
Hello
I have a remark about the e-learning "Standard Simulations", ... We can't get, from time to time, a "right or wrong" answer to the "Standard Simulations" certification questionnaire. It's just a remark, because it would be nice to have an answer to the question asked in the questionnaires themselves.
PS : See attachment.
...@+.