Hello
I have a remark about the e-learning "Standard Simulations", ... We can't get, from time to time, a "right or wrong" answer to the "Standard Simulations" certification questionnaire. It's just a remark, because it would be nice to have an answer to the question asked in the questionnaires themselves.
PS : See attachment.
...@+.
Hello
Thank you for your remark, but can you elaborate. What do you mean by "from time to time"? Is it only on this "Standard Simulation" course or on other modules? A priori, all the questions on the validation MCQ are identical.
Kind regards
In fact, the principle of certification is not to give you the answers to questions! Since you can retake the questionnaire until you get the right result, it is up to you to look for the right information either by going through the training modules again , or by relaunching the certification MCQ.
After each chapter of a module, a few "Final Test" questions are proposed in relation to what has just been seen. In this case, answers may be offered because you are in a learner's position.
Hello
And thank you for your answer, indeed there is in this training module, we sometimes have the "correct answer" and "wrong answer", and it would be nice to have an answer that is not displayed on almost half of the "standard simulation certification" questionnaire.
But this is only a remark.
Kind regards.
OK, I note the remark for the next e-learning modules.
Thank you
Kind regards