Hello
I can easily create a new coordinate system under SW2015.
Can SW give me the angles that allow me to go from the original coordinate system to the new created coordinate system?
do you have to create sketches (musts) in XYZ for construction
on each reference point
and dimension in angles
@+
1 Like
Hello
Could you imagine what you want to do?
If you create a new coordinate system, it's probably according to the parameters you indicated (edges, lines, sketches, etc.) in relation to the basic XYZ coordinate system, so why would you want SolidWorks to give them back to you? Is it for a drawing?
1 Like
In fact, I create a coordinate system by projecting a point onto any 3D surface. I then create a segment that is normal to this surface and that goes through the created point. All I have to do is create a noun segment to orient.
I can create a new coordinate system without first entering the rotation angles
I would now like to know the rotation angles that allow you to go from the original coordinate system to this new coordinate system.
The solidworks measurement tool does not give an angle in this case, it only gives the XYZ position of the coordinate system origin (Euler angles?).
repere_point_2.jpg