Hello
When I put balloons with article number in a drawing sheet it starts at number 8 and not at number 1, how do I put the counter back to number 1?
First of all, a silly question. Did you set up a nomenclature?
It must come from your nomenclature. We should uncheck the "do not change the numbering of articles"
If it doesn't come from that, you have to right-click on your drawing view = > property. Then check that you have checked "link the text of the balloons to the specified table
sans_titre.png
5 Likes
Thank you for your answer, in fact I never use automatic bubbles or article numbering, I usually put blank bubbles that I fill in, I just had the technical support who told me that the article mutation was linked to a nomenclature, I thought I thought that by putting the bubbles one after the other it would number them 1.2..3.4.5..... But no, it doesn't work like that. I'm going to do as usual.
Thank you
It's a shame to do without the nomenclature and the car bubble. But you must have good reasons:)
Good luck. Never pleasant to have to do without automation
3 Likes