Solidworks BOM Numbering

2D plans
1

Hello

 I have a problem with the bill of materials, at first I used a bill of materials with detailed numbering by checking the list of welded parts, I started  the bill of materials with the number 2, but the elements of the bill of materials do not follow the order of the sub-assemblies (e.g.: The set starts with 2, then the subset starts with 2.1, then the subordinate element starts with 2.2.1 instead of 2.1.1). And to correct this problem, I checked "follow the order of the assembly", and indeed, the problem has been corrected, but the numbering of the balloons differed from that of the nomenclature (knowing that the balloons are indeed linked to the same nomenclature.


capture_1.png
capture_2.png
2

 

 

3

Hello 

For my part, I strongly advise against the architecture of a nomenclature pointing to

set>subset>CS elements but rather

one cartridge with overall nomenclature, a second cartridge with the subassembly > CS elements

(the part with the designation "** 200" and "** 250" are used in the main assembly and in the sou set "** 150", so if I follow your architecture I would have two article numbers for the same part which is not logical) 


001-3.png
002-2.png
2 Likes