Hello
I will need to do a 1/2" NPT tap but can't find it when I open the drilling wizard. However, I can find it in the database with the tapered threads. If someone could enlighten me because I'm blocked.
Thank you in advance.
.
See the ANSI INCH standard
as below
@+
4 Likes
2 Likes
Thank you for your answers! Of course, if I don't look in the right place, I'm not going to get out of it! Thank you again.
2 Likes
Hello
It takes a little time (quickly saved later) but it's worth creating a "Drilling Assistance Standards" with the "Toolbox Settings" tool in order to group the standards and type favorites, personally I find it quickly painful to navigate between the 36 standards even when you know where to look.
2 Likes
Totally agree with @dbz +1
It's like all libraries
it is imperative to create your own library in a space outside the SW
to be able if SW version change to keep your own library
@+ ;-)
1 Like
Correct! and it's done for the 1/2 NPT because I'll have to use it quite often.