Hello, I'm setting up my Toolbox in the "drilling wizard" section.
I would like to change the drilling and tapping depths for certain screw sizes. Unfortunately I can't find where to modify these parameters which appear as "end condition" and "thread" in the "propertyManager".
Do you have a lead?
Thanks in advance
Hello
In my opinion, we can't change these values, For the thread, as indicated in the "propertymanager" in the case of a blind hole it's 2 x the diameter, as for the end condition, it's probably a function (% or calculation) of the thread length.
Note, when you hover the cursor over the chain icon next to the values, a message is displayed that says: "Automatically calculate the depth of the blind hole" and for the other: "Automatically calculate the depth of thread"
Thank you for your answer, I have already explored these avenues:)
I'm looking for the parameter that allows you to calculate the drilling and tapping depth, the famous "2x the diameter".
Is it a value that is entered somewhere, or is it a ratio? Where are the parameters of the drilling sketch?