Hi all
I want to create a mechanically welded table on a part in SOLIWORKS
This room is well configured in relation to the models in force in the design office and the access paths are also well defined.
These configurations are the same as my colleagues who don't have any problems generating this table.
When I want to insert the table of mechanically welded parts, only the cartridge appears.
Is it not coming from the paths but from a checkbox in the system options?
Thank you for your help
parametrage_liste_des_pieces_soudees.jpg
Hello
You are not in multibody without having used the "welded construction" option. " ?
This could explain the problem
1 Like
Thank you for the feedback.
No I'm not in multi body or even attachment
mecanosoude_pour_table_des_debits_matiere.jpg
The list of welded parts doesn't seem to have been recalculated (but that shouldn't be the problem)
Do you use the same profile libraries as your colleagues?? (there must be some info (about the section) that comes from there).
On the MEP, the table must be linked to a view (so there is a view of your model on the MEP and the table is linked to this view)?
I don't see too many other possible reasons
1 Like
Good evening
I don't see any differences with my colleagues
Of course, the table refers to a view, so back to the starting point.
Thank you for your involvement.
I'm thinking of logging a ticket to VISIATIV in a short time to try to solve this problem.
Hello;
Have you rebuilt your soldered parts list (Update) of your *.sldprt?
If so, what does its "Summary" look like (Right Click + Property).
Also pay attention to the Configurations, on your drawing view and on your BOM table.
Kind regards.
1 Like
Thank you Maclane for your answer
Following the ticket made, the answer came and I was not well configured.
The "create auto-list" and "auto-update" were unchecked.
The problem is therefore solved.
Thank you all for your help
1 Like
I solved the question with the help of VISIATIV
1 Like