Transition to SW2017

3D Design Volume Model
1

Hello community,

 

Yesterday I migrated from SW2016 SP5 to SW2017 SP4.1

And today, when I want to make some sketches, it's impossible to complete my contours!!!

And when I look more closely, I notice that it's also the hanging of my sketches that is no longer done, the fact that SW immediately puts my vertical or horizontal lines on me...

In short, I think there is something that is checked or unchecked when changing the version.

Help!!!!! Where is this box!!!!

 

 

Thank you in advance for your help

 

Fred

2

Hello

I think the Enable Likement box has been unchecked. You can normally find it in the sketch section of the options. On the 2016 version: Option => Sketch => Enable Likement.

Dimitri

4 Likes
3

Hello

If you have a problem creating a horizontal/vertical line, check As sketched when creating your line. That plus the snapping, no more contour problems (pay attention to the Sketch Snapping options)!

3 Likes
4

Perfect, that was it, thank you Dimitri!

3 Likes