Hello community.
I'm trying to simulate a rotating wheel for a balance calculation: below
I have a built-in part, with a rotating assembly (coincidence point link and another coincidence: point on line -I want to reproduce linear annular and ball joint-)
I can rotate the whole thing by hand, the standard animation and movement work.
I want to measure the forces at both the linear annular and ball joint
I create a motion analysis with circular motor (below)
When I launch the calculation nothing moves (I checked:animate during the simulation) and neither does the reading.
Below is the text of the solver
Question: Why is my motor not driving assembly? (I doubt my affairs)
Do you have a lead?
in PJ the P&GO of the set
CDLT
Vv
appel_lykoa.zip