On a drawing view I have several holes of different sizes, including a type repeated 101 times...
So I made a drilling cable with REP TAILLE QTé.
My question, well my questions:
Can we modify the mark to show only one (so far I managed to hide the others) but that the last mark threatens the number of repetitions of the piercing?
If not, is it possible to change the drill symbol by type of drilling? This would be much more readable on my drawing
As a reminder, I don't need the coordinates, just the depth and the diameter.
Yes I've done that before, but it's more about the view, not the table.
I end up with an overloaded view of "A" to locate the holes.
I wish I could point to a single "A" hole and add the number of occurrences of it.
Or else don't put an "A" location but rather modify the symbol of the drilling (for example put a circle with a cross in the middle for a Ø3 drill, and a circle with a triangle in the middle for the Ø5) with a symbol per type of drilling and then add the reference in the drilling table.
To hide the "A","B"... You can right-click hide on a multiple selection. To display the quantity you can do this with a symbol for drilling that indicates the amount (of the repeat) with <NUM_INST>, but to add a symbol to highlight this or that size/type of piercing, I dry. At the limit you can put Centering Symbols that you put in a particular color depending on the drilling, or put the edges of the holes in another style of line but it's going to be long.
As a result, you can't edit the piercing symbol, at least not easily.
So I have the last solution to hide all the marks created by the drilling table, and then to add a symbol for the drilling, which I edit by deleting everything and leaving only <NUM_INST> + the rep of the table.
Is there a variable to link the drill table mark ("A" "B") to the drill symbol note?