Hello
I created a sketch in an assembly so that I could create constraints.
For practical reasons I would like to convert this assembly sketch into a sketch of a new part of the assembly.
Is it possible and if so how to take it.
FYI I tried to convert my assembly sketch from my parts sketch with the convert function but it doesn't work.
Thank you for your insights.
Hello
If yes, it works, when you're editing in your room (and in the assembly), you click your plan and "Sketch" in order to enter a sketch in the room, you click on the sketch of the assembly to be converted and on "Convert entities", I often do it and I just tested it and it's OK!
Hello
I found out why it didn't work. My assembly sketch is in line of constructions that's why I couldn't convert it. Once the construction lines are converted to a full line, the convert entities function works.
Thank you