Can you roll a part from a flat in SpaceClaim?

Other sections CAD Materials
1

Hello

I have the flat of a piece with perforations and I would like to roll it in SpaceClaim. Is this possible? And if so, how?

Thank you in advance.

2

Hello, I don't know enough about SpaceClaim.

But my methodology is to draw my rolled piece, then lay flat (unfold function), trace my cuts, then go back to folded mode.

It works under SpaceClaim.

Kind regards

3

We tried to do it like that. Except that he wants to go for 3 or 4 Ø but as soon as there are too many of them he no longer takes them into account.

4

Hello I don't have this PB I'm in 2014 version

5

I tried again, it works. This was a problem in the basic design of the piece.