When you change the zoom in SolidWorks, the part (which is not necessarily complex) disappears from time to time.
It reappears after you change the zoom again. But this is not an effective way to work.
You need to update the drivers of your graphics card.
See the link below:
http://www.solidworks.com/sw/support/videocardtesting.html
3 Likes
+1 flegendre it's the graphics card
Yes, that was the first thing I tried (updating the drivers). And that didn't solve the problem.
Can you tell us the configuration of your position?
Processor
RAM
Video card
And the software version.
Thank you =)
Hello Andreas,
I had this same problem and also thought that it was my graphics card drivers but these were well up to date. The issue has been resolved by upgrading to the higher service pack if available. I was at that time on SW2013-SP3 and switched to SW2013-SP4 and since then finished the display problem.
Kind regards
2 Likes