Drives the dimensions of a part from an assembly via a part family

Out of category
1

Hello 

I have created part families for each part of my assembly, I would now like to know if it was possible to link these different families to the one of my assembly (for example: make sure that if I change the diameter of one of my parts, the diameter of another follows accordingly)

I can't create a configuration because there are too many variables and I would have to create a good hundred configurations (which would be anything but practical)

EDIT: I'm under Sw 2018 

2

Hello

In view of the date of the question I hope you have found the solution.

You have to make connections between pieces through the sketches.

I've already made a tutorial on this subject

https://www.lynkoa.com/tutos/conception-3d/pilotage-de-diff%C3%A9rentes-pi%C3%A8ces-dans-un-assemblage

1 Like