Less than 90° bending

3D Design
1

Hello

I would like to make a 45° fold in sheet metal.  But next to the corner, I have a small padlock that writes to me that I can't make folds less than 90°

What is the origin of this? How to remove it?

Thank you


capturepliagesolidworks.png
2

Hello

I just did a test  on SW19 and it works.

Cdt

Fred


pli_a_45deg.jpg
1 Like
3

I don't doubt that it works with others but do you know why this message is displayed?

Do you use a template table?

Thank you

4

no I don't use a template table

5

I think it's because  of the tangent fold (see attachment, if you try with the other 2 that are next to it will work


pli_a_45deg__2.jpg
2 Likes
6

Hello

Below your rating of 189 you have selected the 3rd icon for the dimension taking, choose either the 1st or the 2nd and it should work.

1 Like
7

It's perfect

I feel a little stupid with something so obvious 

8

If it hadn't happened to me I wouldn't have known about it because I also searched like crazy...

2 Likes
9

Ditto :-)

 

10

Hello @marius.poyard 

Please designate the answer that helped you because this will have the effect of closing the forum question and helping another person who might have the same problem.

Kind regards

2 Likes