Hello everyone, I would like to unfold a crush fold using an unfolding table, it does not work at least with my table, I don't know if it and misfill the column of 180° yet there is a loss to the bends of setting? the other angle it works, I put you a screenshot, thank you for your answers
Marco.
Hello,
For my mart, I have never managed to get SW to work with a loss at the bend on a crushed bend ! Even with the folding charts of the bending machine!
In my old job, I set it to the K factor at 0 with reference face indoors and the DVP was fine.
It may not be a miracle solution, but for me it worked...
Good luck.
1 Like