Sheet metal folds and counter-folds

Out of category
1

Hi all.

I have a piece of sheet metal, more or less in the shape of a triangle, with folds and counter-folds to stiffen. For the folds no worries, but inevitably the counterfolds intersect on one side, and impossible to find how to adjust them properly. I'm on SW19, I'll put a screenshot for you. I hope I expressed myself well.

Thanks in advance!


capture_decran_104.png
2

Hello

Can you also put a screenshot with your folds intersecting so that we can better

3

Hello

Of course

Seen from below


capture_decran_106.png
4

Can you share your piece with the crissses that intersect because I can't see too well there.

5

I see 2 possibilities:
- it is possible that SW knows how to adjust the 2 counterfolds if they are made in the same function;
- otherwise, the sketches must be modified to anticipate the collision

1 Like
6

Thank you!

Mea culpa, when I start again SW has automatically adjusted, on the other hand I have one of the folds which is rather strange


tole_pliee.step
7

Are these the ones you want?


tole_pliee_ac_cobra_427.sldprt
2 Likes
8

Hello 

That's exactly it! Thank you very much!!