Hello
As we did at school when we were on the board, we started by placing our views on the paper, with identical gaps between them.
Do you know a way on creo 2 to place the views on the page with identical deviations?
Thank you in advance.
1 Like
Hello
Going to the view properties, Category Origin.
The view can be placed in relation to its center or an element. (see attached image)
Personally, I always place them in sight.
It's not like on the board, the views line up automatically.
S.B
vue.png
4 Likes
Re
Thanks, but this method just allows you to position the views absolutely in relation to their center, what I would have liked is for it to take into account the dimensions of the view, but I think it doesn't exist.
1 Like
In this case, I think we should go over the manual.
You can create a temporary line between your 2 views and then a line between a view and the edge of the sheet. Then you dimension the lines to readjust your views according to the result.
You can also use the grids to place the views.
S.B
2 Likes
Yes I think the easiest way is to make lines like I did on a board, or to put the views in front of your eyes.
Thank you for your help
1 Like