Possible to set or configure a "logo"

Out of category
1

Hi all

I'm trying to configure/set up a part with a logo.
Basically a washer with a logo.
I would like to make them on several washer diameters while increasing or decreasing the size of the logo.

Is it possible?

Thank you.

Kind regards.
 

2

If your logo is drawn in sketch mode with dimensions, you can configure it without any problems.

1 Like
3

 @stefbeno

Okay very well, thank you!

I almost managed to do what I wanted!

I did by making "configurations", by modifying the dimensions of the sketches for each configuration etc ...

I wanted to do at first with equations but maybe not possible or too complex