Problem with Routing Model

3D Design
,
1

Hello

I'm having a problem creating my routing.

Indeed, I have an error message saying: "no valid configuration could be found for this pipe"

I have configured my flange models, pipe and elbow (connection point and routing point type "assembled pipe"), I have my file locations of the system options that point to the right folders, and well my configurations present in the routing library manager under the tab "database of pipes and tubes".

So I dry completely.

Thank you in advance for your suggestions.

Nicholas


issue_1.png
issue_2.png
issue_3.png
2

Hello

Can you check that the values of the connection pt diameters are the same with NominalDiameter@FilterSketch of the pipe?

P.J.: Two screenshots to show you the correspondence between the connection points and the tube diameters.

Jeremy.


capture_decran_2022-09-21_100119.png
capture_decran_2022-09-21_100652.png
2 Likes
3

Hello etudes_20,

Thank you for your feedback.

Indeed, there was a typo at the level of the diameter of the connection pt for a single DN (so not easy to find it, I had to review everything).

I close the subject

4

Hello @Nicko . To close the topic, you need to accept @etude_20's answer as a solution. Thank you

2 Likes