I make a boat hull and at the time of "extruding" I have a problem of connection. I would indeed like to "fill" the crevasse between my two hull parts (Clear photo in PJ).
Do you have a solution?
Thank you in advance.
probleme_connexe.png
probleme_connexe.png
Hello
I don't know about CATIA, but in SW there is this type of problem when the two surfaces are not connected tangently.
To do this, you have several solutions: either you correct your sketch so that it is tangent and your faces correct right away, or you cobble together (more or less well) a connection between the two faces.
1 Like
If you post your model will be easier to help you I'm in R27
Thank you Pierre S!
Franck I put a photo in PJ which illustrates the problem well:)