Hello
I've had a problem since last night. My problem is that when I open solidwork the quick launch window is offered so much that the modification graphics window is not displayed even though it is open.
I'm attaching the photo of the problem, thank you
Hello
It may be due to an update of the graphics card. See if there was one that was done yesterday.
I looked and I reitialized the solidwork file
Thank you
Hello @ juilliardq
If by chance you come back to the forum, can you tell us if your re-init has solved your PB.
Especially since you have a student version.
Kind regards
Hello @Zozo_mp,
The reset worked from the registry.
Just replace Solidwork with Solidwork Old so that when it starts it recreates a file.
Here is the procedure:
Start> Run > regedit and then rename the folder with _OLD at the end for example (to reset to factory settings.