When I want to use the piercing tool, I get an error message that appears: "Out of memory or other error in trying to initialize the data source from the standards file"
What should I do?
Thank you
When I want to use the piercing tool, I get an error message that appears: "Out of memory or other error in trying to initialize the data source from the standards file"
What should I do?
Thank you
Turn off and restart the machine.
Hello
We also had this problem in the past for the
1) Clean up the temporary
2) Solidworks Reemmere
is normally its should pass
Well these are a temporary solution but it works :)
tell me again since I don't know which version of solidworks you have:) but in any case in 2014 its march:)
it's been more than 6 months since we didn'^_^ t have to worry
Delete File