Hello everyone,
A small problem on a radius dimension (see PJ); I can't pull the rib towards the room to make it shorter...
Indeed, the coast is always in the same place and the line is shortened.
Does anyone have an idea???
Thank you
a.png
Hello everyone,
A small problem on a radius dimension (see PJ); I can't pull the rib towards the room to make it shorter...
Indeed, the coast is always in the same place and the line is shortened.
Does anyone have an idea???
Thank you
A bit of a silly question, did you try to remove and put the rating back on?
yes I tried in vain!!
To close and open Solidworks?
Because it's a really weird problem
Hello
Have you tried playing with the options in Document Property > Dimension > Radius??
At the bottom of these options, there are 3 boxes, in my opinion, you should have the last one checked.
Personally, I have the one of highlighted and I can put my ribs well.
(SEE IMAGE)
EDIT: if you check the same options as me, you will be able to place your rib as you want and you will no longer have the attachment line that goes from the center of your circle to your rib, you will just have an arrow pointing your bow.
EDIT OF THE EDIT: in fact, you have to uncheck "display with the continuous attachment line" so that the attachment line no longer goes to the center of your arc.
Plural of Monsieur
I just tried all your solutions without results, it's really surprising...
Joss I have the same configuration as you and my coast doesn't want to know anything.
Did you uncheck "display with the solid attachment line"?
If so, well I admit that I don't really know, maybe you can reset your Solidworks settings?
I have a SW version:
Solidworks 2014 x64 Edition
SP 4.0
Maybe it comes from my version?
Isn't the rating simply centered?
so it will always return to its position.
edit: with an image...
THANK YOU OPIE,
That's exactly it...
Issue Resolved
thank you again