Hi all
Here I have a small problem with SolidWorks simulation.
I have selected the parts on which I want to exert a force but it is impossible to check anything other than " by entity ". I would like to click on " total " but impossible.
Is it due to bad handling, if so, which one?!
Thank you for your feedback.
Hello;
You should select (parallel) faces rather than all functions and bodies.
Avoid Beam mode.
and I advise you to break up your rehearsals (a common source of errors on my studies).
…
It would be easier with an overview of your building tree and your rooms (if that's possible)...
Kind regards.
Hello
Ok thank you I'll test in this direction and break up the repetitions.
