Hi all
I have a doubt about an answer to the HQ "General use of Solidworks.
The answer is yes for an exploded view for a part, there I have a doubt, for an assembly it's ok for me as far as I know.
Thank you for clarifying me on this subject. Thank you in advance.
Kind regards.
AR.
Hello
I haven't tested it on a multi-body part yet but I think it should be feasible in the same way as in an assembly.
Hello Ac_cobra_4227,
Also I have never tested on a multi-body part, but I still don't see the point...
@+.
Hello again to all,
I'm trying the exploded view of a part "in volume body form", indeed it works.
So I conclude that it is possible to make an exploded view of a room.
That's right! We can't all know, that's why this site exists... OL.
@+.
AR.
See screenshot.
I think this option was created for people who only work in multiple parts and there are more than you might think...
Good to know, it can be rampant on a mechanically welded part that is a little complicated.
YES!!!! Hello Stefano, ... Have a nice day