What is the definition of an enclave on solidworks 2017 quotation

2D plans Layout
2

Hello

Apparently Enclave in the Solidworks language means Envelope, here is attached a link that explains this:

http://forum.solidagora.com/cotation-geometrique-mise-en-plan-t2834.html

and again:

http://jm.karrer.free.fr/documents/gps1.pdf on page 3

Kind regards

6 Likes
3

Indeed, this E that we put after a tolerated rating (most often adjusted) refers to the Envelope Principle (also called Taylor's Principle).

1 Like
4

Thank you all

5

Hello

I have a hard time understanding the best answer, "Thank you all" is not the answer to your question in my opinion!!!

See http://www.lynkoa.com/aide : "General and good practice" questions

The right choice serves above all to have at a glance the question followed by the answer that solved this problem.

Kind regards

1 Like