Hello
I would like to recover the value of the volume of my part (3D) when I make my drawing. I've tried several "formulas", including $PRP:"SW-volume" but it doesn't work.
Someone has an idea.
thank you in advance
Kind regards
Christian
Hello
I would like to recover the value of the volume of my part (3D) when I make my drawing. I've tried several "formulas", including $PRP:"SW-volume" but it doesn't work.
Someone has an idea.
thank you in advance
Kind regards
Christian
Hello
You just need to create a property in your part document that points to the SW value.
Then in your drawing, you just have to link your annotation to the property created on your 3D.
See attached files (attention SW2017).
Kind regards
Hello
Otherwise the command to put on the MP is: $PRPSHEET:"Volume"
And have filled in the volume in the properties of the part file, as @jmsavoyat specifies.
Hello
It works if the custom properties are filled in.
Thank you